Latest vehicle recalls

Certain motor homes equipped with draw tite hitch receivers may be missing one or more welds between the hitch receiver box and the bottom support plate.

On certain motor homes equipped with samsung microwave ovens, models mr1031wb, mr1032bb, mr1033sb, mr1351wb, and mr1352bb, the microwaves were produced with a defective panel. An electrical short can occur between circuit patterns on the membrane panel...

Certain pickup trucks fail to comply with the requirements of federal motor vehicle safety standard no. 201, "Occupant protection in interior impact." An area on the rear pillar where the rear seat belt upper anchor is attached may not be sufficiently...

On certain school buses built with vandale lock systems, the system does not provide an audio sound to warn the driver that the emergency door is locked while the vehicle is in operation.

Certain mini trailers have inadequate welds to the tongue and frame assembly. This could cause separation of the tongue assembly from the frame.

Certain trucks fail to conform to the requirements of federal motor vehicle safety standard no. 120, 'Tire selection and rims for motor vehicles other than passenger cars.' The tire pressure was omitted from the vehicle's certification label.

On certain passenger vehicles originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio...

On certain passenger vehicles, the camshaft position sensor may melt resulting in a burning smell and visible smoke, which may subsequently lead to the melting of the camshaft cover and the camshaft position sensor wire harness.

On certain passenger vehicles equipped with 8 and 12 cylinder engines, the digital engine management control (emc) units were not produced according to specifications.

On certain sedan and wagon model vehicles, the left front bolt that retains the forward part of the driver's seat to the seat slide rail may loosen. If the seat slide rail bolt loosens, it will eventually fall out, and the seat may separate from the seat...

On certain pickup trucks, the frame may have a center rail section flange that was not formed properly.

On certain vehicles equipped with curtain shield air bags (csa), one or both of the curtain air bags may be twisted near the inflator due to improper assembly.

On certain passenger vehicles, the flat tire monitoring system has not been correctly programmed. In the event of a flat tire, an audible signal will not sound to alert the driver to a flat tire.

Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 201, "Occupant protection in interior impact." During testing, the free motion head form registered a measurement marginally above the permitted...

On certain school buses chassis equipped with caterpillar engines and hydraulic brakes. A braided ground strap for the starter may rub on a steel chassis brake line potentially causing a fluid leak.

Certain trw driver's side seat belts manufactured on december 6 and 9, 2002, for use as replacement equipment for 1997 ford escort 4-door and station wagon platform vehicles, ford's p/n f7cz54611b09aac. The seat belt assemblies exhibit a no-lock condition...

On certain passenger vehicles, the battery cable fasteners at the bulkhead stud may not have been properly tightened.

Certain motorcycles, a significant quantity of oil lubricant can leak on to the rear wheel and tire from the oil cooler.

On certain fifth wheel and travel trailers equipped with samsung microwave ovens, models mr1031wb, mr1032bb, mr1033sb, mr1351wb, and mr1352bb, the microwaves were produced with a defective panel. An electrical short can occur between circuit patterns on the...

On certain sport utility vehicles equipped with 3.7L engines only, two valve cover studs may interfere with the fuel injector and alternator wiring harnesses.