Latest vehicle recalls

Certain heavy duty class 8 trucks fail to comply with the requirements of federal motor vehicle safety standard no. 120, "Tire selection and rims for motor vehicles other than passenger cars." The weight certification label which contains front gross axle...

On certain heavy duty trucks, the bolts and locking nuts used to hold the brake spiders or brake anchor plates tight to the axles were under-torqued on the right side of the vehicles. If the clamp load on the bolts is not sufficient, the anchor plate may...

Certain motor homes equipped with norcold refrigerator cooling units model numbers 442, 443, 452, ev452, 453, 462, ev462, 463, ev463, 482, ev482, 483, ev483, 874, and 875 manufactured between january 1987 and may 1995. These refrigerators can experience a...

On certain passenger vehicles, the air bag electronic control unit (ecu) is designed to sense and discriminate frontal impact events, command air bag and seat belt pretensioner deployments in a timely manner, and perform continuous diagnostics of the air bag...

On certain passenger vehicles, some front seat back recliner gear teeth may wear excessively through repeated use, which could cause the seat back to slip partially rearward when force is applied.

Certain vans were built without a wheel bearing assembly retaining nut, which could lead to a possible bearing separation.

Vehicle description: semi-trailers. These semi-trailers are equipped with suspension bogies that can slide forward and aft to change the axle positions. The bogies slide along a pair of body rails that are welded directly to the bottom flange of the...

On certain front engine school and transit buses equipped with hydraulic brakes, the rear hydraulic brake hose could contact the frame rail and abrade, allowing brake fluid leakage.

On certain van trailers with slide suspensions, improperly applied weld attachment of the upper bogie rails to trailer crossmembers.

On certain school and transit buses equipped with caterpillar 3126e engines and felsted electronic pedal assemblies, an internal return spring on the throttle position sensor was incorrectly manufactured. The spring, which is too long, cuts a trace into the...

On certain pickup trucks and sport utility vehicles, the fuel tank inlet shutter valve does not meet the sealing performance specification.

On certain pickup trucks and sport utility vehicles, water may enter the rear axle housing due to inadequate sealing of the anti-lock braking system (abs) sensor.

On certain pickup trucks and sport utility vehicles equipped with a supercharger, under certain conditions, such as full throttle in low gear when the engine is not fully warmed up and at cold ambient temperature, the amount of intake air flow through the air...

Certain transit buses fail to comply with the requirements of federal motor vehicle safety standard no. 217, "Bus emergency exits and window retention and release." Due to certain seating arrangements, the emergency exit release handles did not fall in the...

Certain transit buses fail to comply with the requirements of federal motor vehicle safety standard no. 217, "Bus emergency exits and window retention and release." Due to certain seating arrangements, the emergency exit labels on the emergency exit windows...

On certain class a motor homes built on either a ford or workhorse chassis, the power feed for the fog lamps may have been mis-wired.

On certain mini vans, the clockspring assembly may have been wound incorrectly during the vehicle assembly process.

Certain passenger vehicles have loose pinch bolts that secure the lower control arm to the steering knuckle have been reported.

Certain passenger vehicles equipped with zetec engines, loose or broken attachments and misrouted battery cables could lead to cable insulation damage.

On certain passenger vehicles, the driver seat belt buckle wiring could be damaged by interference with the driver seat cushion height adjuster mechanism.