On certain mini vans, the fuel tank control valve weld joint could separate resulting in a possible fuel leak.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On some heavy duty class 8 vehicles equipped with arvinmeritor axle assemblies which may have been manufactured with trw model 20edl ball sockets, the tie rod ball-socket bearings have a below specification case depth and/or hardness which can lead to...
On certain fifth wheel recreational vehicles equipped with norcold refrigerator cooling units model numbers 1200lr and 1200rim with serial numbers between 700000 and 1008700 and manufactured between december 1996 and february 1999. These refrigerators can...
Certain sport utility vehicles are missing welds on the rear floor plan.
On certain motorcycles, the braided clutch cable could contact the rear brake line and cause the brake line to abrade over time, resulting in a loss of rear brake fluid.
On certain motor homes equipped with option #149 (norcold refrigerators), the electrical wiring may be pinched at the rear of the refrigerator causing the wiring to short against other wires in the area or metal components of the refrigerator.
Covers2002 Fleetwood Discovery
On certain motorcycles, the side stand legs have the potential to bend or break.
Covers2003 Buell Firebolt XB9R
Certain class 8 chassis fail to comply with requirements of federal motor vehicle safety standard no. 121, "Air brake systems." The installation of the additional axle(s), raises the gvw capability of the vehicle and therefore requires an increase in the...
Covers2002 Mack CH
Certain passenger vehicles equipped with adjustable padels are being recalled in order to adjust the brake and accelerator pedals to a minimum of 50 mm of lateral separation. Simultaneous application of both the brake and accelerator pedals could result in...
On certain passenger vehicles, if the vehicle is driven under repeated start and stop operation in low ambient temperatures and in deep snow, there is a possibility that snow could accumulate in large quantities inside the rear wheel and freeze. The snow...
Certain medium duty trucks equipped with the optional caterpillar diesel engine (lg5) option were built with a misrouted battery cable that could come in contact with the exhaust pipe. The conduit and the nylon cable coating could degrade to the point where...
On certain heavy duty trucks, the joint between the lower portion of the steering column and the upper end of the intermediate steering shaft may have a missing or loose pinch bolt. This condition could also occur at the lower end of the intermediate...
ON CERTAIN MOTORCYCLES, THE FUEL PUMP CAN FAIL.
On certain motorcycles, the throttle linkage can fail to return to a completely closed position.
On certain medium and heavy duty trucks built with driveline parking brake codes 04gar, the parking brake assembly may not hold the vehicle in position when set. Factors contributing to this possibility are as follows: (1) cracked or broken cams; (2) loose...
On certain motor homes, the under hood charging system wiring may be improperly routed and could come in contact with other under hood components.
On certain heavy duty trucks equipped with bendix tc-7 trailer control hand-operated valve with push-to-connect fittings. The delivery port in the valve body may be partially blocked due to a problem during the moding process.
On certain school and transit buses equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from the...
On certain coaches equipped with optional webasto heaters, the heater lines in the engine compartment, above the engine exhaust system, are covered with insulation.
On certain motor homes and fire trucks equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from...