On certain class a motor homes, the floor truss network support system has a potential to weaken causing internal and external features to become misaligned. The affected vehicles are 1999 - 2003 class a motor homes manufactured on f53 20,500 pound gross...
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain natural gas model vehicles, a t-fitting that connects fuel tanks #3 and #4 can develop a leak when the solenoid valves are energized, such as when the ignition switch is in the on position or during refueling.
Covers2002 Ford Crown Victoria
On certain passenger vehicles equipped with 6-cylinder engines, the aluminum wheels may have an off-center diameter.
On certain front engine school and transit buses equipped with blue bird option 40177 cummins isb engine, the alternator power cables may not be routed properly from the alternator output to the starter motor.
Certain coaches equipped with optional restroom fail to comply with requirements of federal motor vehicle safety standard no. 217, "Bus emergency exits and window retention and release." The pushout window located on the right side, at the rear of the bus...
Certain passenger vehicles contain driver and front passenger lap and/or shoulder belt retractors that may not remain locked up as designed during a crash in which the belt pretensioners deploy.
On certain school and transit buses equipped with passenger seat belts with retractors, the cover halves for the retractable portion of the belt can separate completely and release the seat belt connector. If this occurs, one of the load bearing pins in the...
On certain folding tent campers, the federal certification (and rvia) labels have the incorrect gross vehicle weight rating, tire size, and inflation pressure listed.
On certain minivans, sedans, coupes, and sport utility vehicles equipped with v6 engines, a timing belt tensioner pulley on the water pump is misaligned and could cause the timing belt to contact a bolt on the cylinder head. Eventually the belt could be...
On certain sport utility vehicles, a fuel filter fitting can become disconnected. If this were to occur while attempting to start the engine, a no-start condition would result and fuel would be pumped out the fuel filter onto the ground.
Certain motor homes fail to comply with the requirements of federal motor vehicle safety standard no. 120, "Tire selection and rims for motor vehicles other than passenger cars." These motor homes were erroneously assigned inadequate cold tire inflation...
On certain fire trucks built with a steerable auxiliary axle and equipped with certain meritor-wabco brake system two and four port relay valves, the valve may stick open when a high-pressure application is released.
On certain passenger vehicles, the safety belt buckle may "false latch" and expose the driver to unrestrained movement during a crash.
On certain trailers equipped with spring brake control valve assemblies, there is a recessed area on top of the valve in which a brass guide pin fits down inside the body of the valve and is held in place by a steel snap ring. The recessed area allows...
On certain trailers equipped with spring brake control valve assemblies, there is a recessed area on top of the valve in which a brass guide pin fits down inside the body of the valve and is held in place by a steel snap ring. The recessed area allows...
On certain trailers equipped with spring brake control valve assemblies, there is a recessed area on top of the valve in which a brass guide pin fits down inside the body of the valve and is held in place by a steel snap ring. The recessed area allows...
On certain trailers equipped with bendix sr-2, sr-4, and sr-5 trailer spring brake valve assemblies, the molded rubber face of the inlet/exhaust valve (i/e valve) component of the affected valves can separate from the valve's metal insert. Air can be trapped...
On certain trailers equipped with bendix sr-5 trailer spring brake valve assemblies, the molded rubber face of the inlet/exhaust valve (i/e valve) component of the affected valves can separate from the valve's metal insert. Air can be trapped by a separated...
On certain trailers equipped with bendix sr-2, sr-4, and sr-5 trailer spring brake valve assemblies, the molded rubber face of the inlet/exhaust valve (i/e valve) component of the affected valves can separate from the valve's metal insert. Air can be trapped...
On certain trailers equipped with bendix sr-2, sr-4, and sr-5 trailer spring brake valve assemblies, the molded rubber face of the inlet/exhaust valve (i/e valve) component of the affected valves can separate from the valve's metal insert. Air can be trapped...