On sport utility vehicles, there is a breather hose that attaches to the nozzle of the on-board refueling vapor recovery (orvr) valve, which is located on the topside of the fuel tank. The breather hose is attached with a clamp, whose "tabs" face in the...
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain passenger vehicles with 36,000 miles or less as of july 15, 2002, an electrical contact problem may have developed in the hazard switch which could result in inoperative hazard lights and/or inoperative turn signals.
On certain motor homes built on chevrolet g-van chassis, it is possible, that on some units, the passenger side seat belt was not assembled correctly to the structural member of the vehicle. The swivel plate may not be attached to the bolt holding the...
On certain heavy duty trucks, the fuel line is routed too close to a turbo charger outlet/exhaust pipe. If an interference condition occurs between the fuel harness and the exhaust pipe, the fuel line inside the reflective heat wrap could melt due to...
On certain school buses and heavy duty trucks built with international vt365 engines and manufactured at international diesel of alabama. The injector driver modules (idm) built for the vt365 engines could have missing vibration damping/retention shells and...
Certain medium duty trucks equipped with 11,000 lb. Rear axle have a condition where the rear axle anchor plate may fracture. As the anchor plate fractures, there is an audible "bang." If this indication of a condition requiring the driver's attention went...
On certain passenger vehicles equipped with manual transmissions, the transmission shift cable connects the gearshift lever in the vehicle interior to the shift linkage on the transmission. It is possible for the shift cable to detach from the transmission...
On certain passenger vehicles, the fuel tanks can leak.
On certain diesel pusher, and class a motorhomes, a bracket securing the tv in place in the front overhead cabinet above the driver may not support the weight of the tv.
On certain low floor 29, 35, and 40 foot buses, the steering gear input shaft bolt installed was a 3/8" diameter coarse thread grade 8 fastener instead of the required 7/16" diameter fine thread grade 8 fastener.
On certain passenger vehicles, some of the passenger air bag modules were not properly welded and may not deploy in a collision.
On certain passenger vehicles, due to a manufacturing problem, the brake pedal arm pivot shaft could loosen from its support bracket.
On certain tour type coaches equipped with parcel racks, irregularities in the installation of the fasteners used to retain the parcel racks to the coach structure could result in the fasteners loosening allowing the parcel racks to fall without warning.
On certain streetcars (diesel and cng models) and rt-52 diesel coaches manufactured with at-545 and mt643 transmissions which use a manual transmission control cable. The transmission control cable may rub against the junction box power stud located on the...
On certain motorcycles, it is possible that the hex nut that secures the wheel to the gearbox output shaft was tightened incorrectly during the vehicle assembly. As a result, the nut could loosen during vehicle operation. If this happens, the belt wheel...
On certain motorcycles, due to a manufacturing defect, it is possible that the wheel could develop a crack. Over time, the crack could worsen to the point that the wheel failed and the drive belt derailed.
On certain motorcycles, the fuel tank bracket washer and damper do not adequately protect the tank from engine vibration.
On certain trailers equipped with wabco 4s/2m system, the electrical and air connections are improperly connected.
On certain passenger vehicles and limousines, the low pressure brake fluid feed pipe between the master cylinder and remote reservoir has the potential to trap or retain air.
Certain transit buses fail to comply with requirements of federal motor vehicle standard no. 101, "Controls and displays." This standard requires specific labeling for "engine start" and "engine stop." The wording of the labels on these vehicles do not...