Latest vehicle recalls

Vehicle description: heavy duty trucks. The steer axle mudflaps and/or mudflap stiffeners can rub a hole in the forward surface of the undercab fuel tank, causing a hole in the fuel tank.

Vehicle description: sport utility vehicles, equipped with a floor mounted rosen video entertainment center, fail to conform to the requirements of fmvss no. 301, "Fuel system integrity." Due to the method of installation of the video entertainment center...

Vehicle description: heavy duty trucks equipped with eaton autoshift gen ii transmission assemblies. Due to a software problem in the transmission assemblies, the transmission will select the wrong gear.

Vehicle description: medium duty trucks. The steering gear box is mounted to the frame using a combination of two (2) mountings bolts with nuts and two (2) mounting studs. The two mounting bolts thread into mounting nuts that are welded to the inside of...

Vehicle description: passenger vehicles. Due to improper heat treatment, the rear axle may not have adequate strength in some areas.

Vehicle description: heavy duty trucks equipped with eaton autoshift gen ii transmission assemblies. Due to a software problem in the transmission assemblies, the transmission will select the wrong gear.

Vehicle description: heavy duty trucks equipped with eaton autoshift gen ii transmission assemblies. Due to a software problem in the transmission assemblies, the transmission will select the wrong gear.

Vehicle description: van-refrigerated/dry freight trailers equipped with conmet pregreased trailer hubs and a tire inflation system. The outboard bearing on the pregreased trailer axle hubs used with the tire inflation systems may fail due to the intrusion...

This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: 1/2 ton light duty pickup trucks. On certain trucks, failure to follow the service procedure set forth...

Vehicle description: heavy duty trucks built with international code 16sch (lower bunk webbing restraint). Incorrect bolts were used to hold the bunk webbing restraint latch brackets to the bunk base.

Vehicle description: school/transit buses and medium duty trucks. The castings used on the power steering pumps were not built to match the engineering drawings, resulting in a thin wall in the pump casting or a complete connection of two passages that are...

Vehicle description: certain tractors fail to comply with fmvss no. 121, "Air brake systems." The air lines may not be routed properly to the drive axle service brake relay.

Vehicle description: heavy trucks built with air brakes that did not have air gauges installed. This does not comply with requirements of fmvss no. 121, "Air brake systems."

Vehicle description: motorcycles. The side stand assembly can become loose and detach from the motorcycle.

Vehicle description: low floor transit buses. These vehicles do not comply with the requirements of fmvss no. 108, "Lamps, reflective devices, and associated equipment." The reflex reflectors on the side, front (amber) and rear(red) positions are missing.

Vehicle description: these vehicles do not comply with the occupant protection requirements of fmvss no. 201, "Occupant protection in interior impact." The console cover on these vehicles does not stay closed when a specified vertical load is applied.

Vehicle description: passenger vehicles equipped with rear drum brakes. The bolt head(s) on the rear spindle rod can separate.

Vehicle description: passenger vehicles equipped with active cornering enhancement (ace). The loading conditions on the vehicle's left side engine idler pulley can exceed the maximum calculated figure of the original design specification. The material of...

Vehicle description: a windshield wiper control module may not be capable of carrying the current required during high load conditions on the wipers (i.E., Ice, snow, or other debris).

Vehicle description: passenger vehicles. Due to an internal defect in the circuitry of the blower motor regulator, the regulator may overheat.