Latest vehicle recalls

The wiring from the electronic control unit was connected to the wrong wheel sensor or to the wrong brake modulator valve. It is possible that either or both wiring may have occurred at either the front or rear axle or both axles.

Vehicle description: school buses built on gm p3 cutaway chassis. The school bus, when tested in accordance with fmvss no. 301, Exceeded the allowable fuel spillage as specified by the standard. The fuel tank was punctured as a result of the impact of the...

The latch plate used in the seat belt buckle was not manufactured according to design dimensions. If the seat belt tongue is inserted slowly at an angle into the buckle, there is a possibility of partial engagement.

The equalizing beam shaft of the tandem axle suspension were manufactured from as-rolled sae4140 steel rather than the specified annealed sae4140. These shafts can fracture inside the beam at the toe of the weld.

The bed assembly can bypass the stop mechanism allowing it to separate itself from the bed track.

Vehicle description: school buses built on gm p3 cutaway chassis. The school bus, when tested in accordance with fmvss no. 301, Exceeded the allowable fuel spillage as specified by the standard. The fuel tank was punctured as a result of the impact of the...

Note: passenger side (right) seat belt assembly. The rail of the automatic shoulder belt can wear sufficiently such that the cable which retracts the buckle assembly will become jammed in the rail rendering the shoulder belt inoperative.

Note: driver's side (left) passive seat belt assembly. The rail of the automatic shoulder belt can wear sufficiently such that the cable which retracts the buckle assembly will become jammed in the rail rendering the shoulder belt inoperative.

The park pawl abutment bracket has a sharp edge which can cause the parking pawl to hang up and not engage the park gear. This would allow the vehicle to move even though the gear shift indicator shows that the vehicle is in park.

An item worn by a child, such as a long drawstring, sash, or backpack/bookbag accessory, can become caught on the fateners that secure the handrail support to the handrail.

The certification labels on the involved vehicles has incorrect rear tire inflation pressure designations. This does not comply with fmvss no. 120, "Tire selection and rims for motor vehicles other than passenger cars."

These vehicles were built with an incorrect wiper blade assembly (17" long instead of 22" long) on the driver's side. This does not comply with fmvss no. 104, "Windshield wiping and washing systems."

With no air in both front axle air suspension air bags, the chassis suspension will lower to the suspension stop. When that occurs, the track bar bracket can contact the axle steering tie rod.

The fuel tank gaskets for the fuel pump and/or gauge unit gasket could have been incorrectly installed allowing fuel or fumes to escape.

The fuel tank gaskets for the fuel pump and/or gauge unit gasket could have been incorrectly installed allowing fuel or fumes to escape.

The rear most axle of the tandem axle set could have inoperable brakes on one or both wheels because the brake s-cam was incorrectly installed.

When the chassis/vehicle is operated on a highway and the cruise control system is turned on, with the speed set, if the stop/hazard fuse has failed, the cruise control will not disengage when the brake pedal is depressed.

The front passenger seats have less lock pawl engagement on the inboard fore/aft adjuster than specified. This does not comply with federal motor vehicle safety standard no. 207, "Seating systems."

The steering column used was incorrectly manufactured. The tube portion of the steering column has a welded end with a specified length of 5.5 Inches. A 3.5 Inch welded end was used by mistake. With the shorter end, it is possible there is insufficient...

Engine block heaters installed as accessories. The block heater contact surface does not match correctly with the engine block as intended. The block heater could come loose from the engine block, and if being used, could possibly overheat causing damage if...