PACCAR Incorporated (PACCAR) is recalling certain model year 2017 Kenworth C500, T660, T680, T800, T880, and W900 vehicles manufactured March 9, 2016, to April 26, 2016 and 2017 Peterbilt 320, 365, 367, 389, 567, 579, and 587 vehicles manufactured March 10...
Electrical system
Kenworth T800 Electrical problems by year
7 complaints filed with NHTSA about the Kenworth T800's electrical system. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.
Electrical complaints by model year
Electrical recalls
Paccar Incorporated (Paccar) is recalling certain model year 2016 Kenworth T370, T660, T680, T800, T880, and W900 vehicles manufactured July 31, 2015, to August 12, 2015, and 2016 Peterbilt 337, 348, 365, 367, 382, 386, 389, 567, 579, and 587 vehicles...
PACCAR Incorporated (PACCAR) is recalling certain model year 2015 Kenworth T660, T800, W900, T400, and C500 heavy trucks manufactured September 19, 2014, to October 30, 2014. The affected vehicles may have been produced with an undersized wire gauge for the...
PACCAR is recalling certain model year 2014 Kenworth T170, T270, T370, T470, T660, T680, T800, T880, and W900 trucks manufactured May 6, 2013, through May 17, 2013; and model year 2014 Peterbilt 330, 337, 348, 365, 367, 382, 384, 386, 388, 389, 389K, 567...
Paccar is recalling certain model year 2011-2012 kenworth t660, t700, and t800 vehicles manufactured from april 19, 2010, through may 13, 2011, and model year 2008, 2010, and 2011 peterbilt 365, 367, 384, 386, 387, 388 and 587 vehicles manufactured from april...
Certain truck equipped with behr cables, the cables were installed incorrectly and are too long.
On certain trucks, the power feed harness p92-1993 terminals were not properly crimped.
On certain trucks equipped with a combination of caterpillar c11/c13 engines and an optional leece neville brushless alternator, a chaffing point may exist between a heat shield on the engine and the wiring for the alternator.
Certain trucks equipped with eaton fuller ultrasonic transmissions fail to comply with the requirements of federal motor vehicle safety standard no. 102, "Transmission shift lever sequence, starter interlock and transmission braking effect." The cab...
On certain heavy duty trucks, the main cab wiring harness was incorrectly connected to the 50 amp circuit breaker instead of the 135 amp breaker.
On some heavy duty trucks equipped with alcoa fujikura ltd. (Afl) power distribution boxes (pd box), the pd boxes were manufactured with insufficient torque applied to the nut of the main power feed-through stud.
Vehicle description: heavy duty trucks equipped with an optional firewall-mounted circuit breaker. The main cab power and battery power leads were attached incorrectly. This condition can result in the main cab power being unprotected.
Vehicle description: heavy duty trucks equipped with caterpillar engines and eaton autoshift transmissions. The engines can stall because of software problems.
Vehicle description: heavy duty trucks equipped with caterpillar 3406e engines. The routing of the electrical and fuel lines can cause chaffing of the wiring harness on the fuel line.
Latest T800 electrical complaints
Tl*the contact owns a 2004 kenworth t800b truck. The contact stated the gear was in the park position with the engine in operation when she exited the vehicle. The contact noticed flames emitting from the instrument panel upon entering the vehicle. The fire department extinguished the flames. The vehicle was towed to an authorized dealer. The cause of failure was not determined. There was a nhtsa recall related to the defect, campaign 04v580000(electrical system:wiring). The vin was not included in the recall. The failure mileage was approximately 240,000.
Booster cable routing and cable mounting on 2002 kenworth found to be cause of fire. *Tr
Booster cable routing and cable mounting on 2002 kenworth found to be cause of fire. *Tr
Booster cable routing and cable mounting on 2006 kenworth found to be cause of fire. *Tr
A tractor update program was initiated by kenworth early in 2009 that involved the 2008 t-800 tractors. The update required the installation of a 150 a "megafuse" into the main positive conductor supplying all tractor electrical power (not to the starter motor solenoid). Since the "megafuse" was installed inline, opening of the fuse effectively de-energized all electrical components in the tractor including the electronic control module (ecm) resulting in immediate engine shut down. Further, all signal,...
Read the full complaint
warning, visibility and head lights ceased operation. More importantly (and the reason for this report), with immediate shutdown of the diesel engine, all power assisted steering capabilities are eliminated. Without power assist, a tractor becomes difficult to control, and may result in a crash. We investigated just such an occurrence for one of our clients. Historically, our trucking company client has now recorded two such electrical failures with one resulting in a crash. The first occurrence happened while backing into a loading dock at low speed. The second occurred while traveling along a northern ontario highway curve at night. The second fuse failure resulted in a crash as the driver could not negotiate the curve in the dark, without the power assisted steering (far northern ontario). The megafuse is housed within the kenworth battery box, located immediately behind the left side fuel saddle tank. At present, we are investigating the cause of the megafuse opening (failure). Preliminary hypothesis included intermittent electrical fault(s) within the main supply conductor or mechanical failure of the megafuse due to vibration damage. Aside from the failure mechanism of the fuse, it is our engineering opinion that a fuse that nullifies the power steering system is dangerous to the health and safety of the tractor occupants and others that may come into contact with a misdirected tractor-trailer combination. *Tr
Tl*the contact owns a 2005 kenworth t800. The contact stated that the clamps that hold the battery cables, which lead from the battery to the starter, were not adjusted properly. As a result, the cables were chaffing. A fire ignited and spread throughout the engine and cab of the vehicle. The fire department extinguished the fire. The insurance adjuster and vehicle re-builder diagnosed the source of the fire. A police report was filed. The manufacturer was not notified and the vehicle has not been repaired. The failure and current mileages were 250,000.
Air leak under dash, caused by power divider switch. *Slc
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data