On certain passenger vehicles, the front control arms may not have been manufactured correctly and, as a result, the stud and nut that secure the arm to the spindle may lose their initial axial tension. Under certain driving conditions, the steering may...
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain motorcycles, the o-ring in fuel line quick-disconnect coupling could become damaged and lead to a fuel leak. There is also a problem involving crimp-type hose clamps, which can result in a fuel leak.
On certain sport utility vehicles equipped with 3.7L and 4.7L engines, the throttle control cable may ingest water and freeze during extended cold temperature.
On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been...
On certain 2003 vulcan 1500 classic, 1500 drifter, 2003-2004 1500 mean streak, 2003 1600 classic, and 2003-2004 nomad fl model motorcycles, high oil pressure upon a cold start-up can deform the oil filter cartridge.
On certain motorhomes built on workhorse chassis and equipped with bosch zops brake calipers, the pads can drag on the rotor surface due to the pin slide.
On certain passenger vehicles equipped with automatic transmissions, with the forward drive gear selected and the vehicle stationary or in a forward motion, the gearbox could potentially select reverse gear, without indication.
On certain motorhomes built on spartan chassis, the angle of the hoses from the hydraulic pump could contact the positive stud on the starter.
On certain motor coaches, incorrect 7.5 Amp fuses were installed in the antilock brake (abs) circuit. The correct fuse is 25 amp.
Certain motorhomes fail to comply with federal motor vehicle safety standard nos. 207, "Seating systems" and 210, "seat bet assembly anchorages." The bolt and lock nut connecting the driver and passenger seats to the slide track were not installed correctly...
On certain motorcycles, accelerator pump diaphragms may be damaged from excessive assembly clamping pressure, which can allow fuel to leak from the pump actuating rod area.
On certain passenger vehicles with direct shift gearbox, during the production of the gearbox, a seam at the clutch was not welded to specifications. This could lead to degraded performance of the clutch inside the gearbox.
On certain sport utility vehicles, the active cornering enhancement (ace) pump banjo bolt looses torque and allows fluid to leak past the joint.
Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standards no. 105, "Hydraulic and electric brake systems," and no. 135, "Passenger car brake systems." The anti-lock braking system (abs) modulator valve...
On certain passenger vehicles, some welds between the passenger's side motor rail and the front bumper bracket do not meet engineering specifications.
On certain traveltrailers equipped with suburban furnaces, the furnace exhaust vent may not be present.
On certain motor homes, glass shower doors are cut and/or treated so that over time could develop sharp edges.
On certain ambulances equipped with goodrich velvet-ride rear suspension systems, the bolts connecting the suspension spring to the rear axle may break.
Certain passenger vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 118, "Power-operated window, partition, and roof panel systems." The power windows and/or sunroof may be operable after the ignition has been turned...
Certain passenger vehicles equipped with 2.2L 4-cylinder (l61) engines were built with a fuel filter that could corrode prematurely on the exterior surface.