On certain heavy-duty trucks, when the bunk is raised into the stored position, an object left on the bunk may inadvertently turn on a bunk lamp.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Certain passenger vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 207, "Seating systems." The backrest locking mechanism on some front seats may have been installed incorrectly.
On certain electric vehicles, the front suspension transverse link's ball joint bracket may break from stress concentration at a notch created by surface roughness and the shape of the material cut-line.
On certain minivans and 4x2 pickup trucks, the vehicle certification label may have gross axle weight ratings (gawr) that exceed the maximum tire load capacity as defined in federal motor vehicle safety standard no. 120, "Tire selection and rims for motor...
On certain 4x4 pickup trucks equipped with the snow plow preparation package, the tires supplied on some vehicles may have gross axle weight ratings that slightly exceed the maximum tire load capacity as defined in federal motor vehicle safety standard no...
Certain motorcycles with carbureted engines which have an angled fuel fitting on the gas tank do not meet harley-davidson impact test standards.
On certain sport utility vehicles, the accelerator cable casing cap that is attached to the vehicle firewall can crack due to extended exposure to forces from the accelerator cable and insufficient long-term durability of the plastic casing cap. If the...
On certain sport utility vehicles, a post within the safety belt buckle covers could fracture, which could affect latch function, resulting in either a "no latch" or "partial latch" condition. In the "partial latch" condition, the buckle tongue can be...
Certain 31' fifth wheel trailers fail to comply with the requirements of part 567. Also some vehicles were f itted with 225/75r/15e goodyear tires and 16" with 235/85r/16e goodyear tires should have been installed.
On certain custom built specialty trailers equipped with dexter axles and crewson automatic slack adjusters, the push rod arms on the axle brakes are too long.
On certain vehicles, the headlamp adjustment mechanism may be operated without suitable instruction on either the mechanism or in the owner's manual. This does not meet the requirements of federal motor vehicle safety standard no. 108, "Lamps, reflective...
On certain passenger vehicles, the tire information label is incorrect identifying the vehicle as a five-passenger vehicle, instead of a four-passenger vehicle.
On certain pickup trucks, the transfer case to transmission attaching fasteners may not be tightened correctly. This could cause the transmission adapter or transfer case housing to crack and leak fluid.
On certain trucks equipped with air brakes, the plastic push-to-connect air line fitting cartridge could be improperly welded into the nylon junction block housing allowing an air line to become disconnected.
On certain conventional style school buses, only those equippped with air brakes, the underhood firewall location of the air brake manifold may permit rainwater entry into the parking brake exhaust port fitting of the manifold. In freezing weather, this...
On certain school bus, xc rv, and shuttle bus chassis manufactured between february 1 and july 18, 2003, incorrect axle steering stop bolts were installed on aac front axles. It may be possible to turn the front wheels in either direction until the tires...
On certain passenger vehicles, the brake tubes for the rear brakes can contact the steering gearbox mounting brackets.
On certain sport utility vehicles, the ignition system wiring harness is routed under the intake manifold. The harness can rub against the manifold during vehicle operation and abrasion damage to the harness can occur.
On certain motorcycles, the wire that provides power to the horn, due to misrouting, can become frayed from contact with the horn bracket mounting bolt. As a result, the horn wire may become exposed, and when the horn button is pushed, either the horn...
On certain dual steer trucks, the right hand steering wheel may not be seated properly on the column shaft.