Latest vehicle recalls

The ignition switch could experience an internal short circuit.

When in the secondary latched position, the driver door latches may open when subjected to transverse loads less than that specified in fmvss no. 206, "Door locks and door retention components."

The left front brake line can contact the transaxle mounting bracket or attachment bolt.

Air suspension torque arm can come in contact with the air brake chamber mounting bracket resulting in broken s-cam mounting bracket.

The wire harness for the power lumbar feature on the seat is underneath the front seat cushion support wires. The support wires on the driver seat can contact and damage the insulation harness resulting in a high resistance electrical short through the...

The fasteners used to secure the mounting foot of either forward or rearward handrails could be installed in such a manner as to allow the possibility that the nut used in nhtsa's handrail inspection procedure will catch between the fasteners.

The air bag electronic control module (aecm) software contains an error which can delay the air bag deployment in certain crash situations.

The drive belt pulley on the engine can develop fatigue cracks in the metal and break. If the drive pulley breaks, the car would not have engine cooling, battery charging, and/or power steering.

These vehicles were assembled with the throttle cable contacting the dash mat which could bind the throttle. This does not meet with the maximum return times required by federal motor vehicle safety standard no. 124, "Accelerator control systems."

A brazilian domestic headlamp was inadvertently installed on these vehicles instead of the required u.S. Domestic assembly. This does not meet the requirements of fmvss no. 108, "Lamps, reflective devices, and associated equipment."

The wires that correspond to the vehicle's rear turn signals were reversed when installed in the electrical connector.

These trucks were not built with inversion valves due to a programming error. The inversion valve provides modulated spring brake application during emergency braking when the "a" portion of the air brake system has failed.

The fan clutch for the engine cooling system fan was combined with an inappropriate fan, which interferes with the drive and can cause the drive to separate.

Passenger's clothing can unknowingly become caught in the handrails at bus doors when exiting the bus.

The seat recliner to seat frame attaching bolts on these vehicles could loosen, fatigue and fracture, allowing the seat back to suddenly recline.

The traction solenoid exhaust can be obstructed due to inadequate drainage and a build-up of road contamination between the mounting bracket and the solenoid housing. The obstructed exhaust prevents the relay valve control air pressure from venting after a...

The awning attached for the slide-out room can unfurl or unroll during transit causing the bracket to rip free of the sidewall.

The coating used to protect the accelerator pedal shaft is incompatible with the bronze bushing through which the shaft passes. Over time, and in the presence of a corrosive environment (water, road salt), the shaft can corrode inside the bushing increasing...

Passenger's clothing can unknowingly become caught in the handrails at bus doors when exiting the bus.