Latest vehicle recalls

The involved vehicles have tire/wheel specification information on the vehicle certification label which indicates a smaller size tire than required. This does not comply with label requirements of fmvss no. 120, "Tire selection and rims for motor vehicles...

An engine wiring harness can short circuit due to contact with the exhaust gas recirculation tube..

The studs which attach the brake master cylinder to the power brake vacuum booster assembly can develop stress corrosion cracking after being operated for an extended period of time in the southern california location.

The rear lower control arm can crack at the rear stabilizer bar attachment.

Vehicle description: multi-purpose passenger vehicles. This is not a safety recall in accordance with federal regulation 573. However, it is deemed a safety improvement campaign by the agency. The campaign will reinforce the bracket attachments of the...

Defective lower control arm ball joint attachment nuts were not properly torqued and can loosen.

Defective lower control arm ball joint attachment nuts were not properly torqued and can loosen.

Contact between the brake chamber and the suspension beam can result in damage to the brake chamber clamp band.

Defective ignition switches were improperly manufactured and can cause some electrical accessories to malfunction.

The brake system fluid level indicator lamp switch can malfunction. This does not comply with fmvss no. 105, "Hydraulic brake systems."

Vehicle description: passenger vehicles manufactured from august 1991 through july 1995. The transmission oil cooler line can separate when the vehicle is operated in low temperatures in combination with high transmission loads.

Intermittent disruption of the functions controlled by the steering wheel center touch pad can occur caused by electrical shortage inside the steering wheel assembly. This does not conform to the requirements of fmvss no. 104, "Windhsield wiping and washing...

These buses are equipped with an entrance door handrail off set brace attached to the interior wall and the handrail. The attachment point at the wall is incorrectly positioned permitting the entrapment of the "connecticut nut/string test device" between the...

The wrong circuit breaker was installed in the electrical panel which could cause an interruption of the 8-light warning system.

A defective control module in the "autolamp" system can malfunction. If the "autolamp" system is being used to activate the exterior light (including headlamps), the headlamps could shut off without warning. This will not occur if the exterior lighting is...

The steering column shaft was incorrectly installed in the vehicle causing the column to be out of alignment.

This is not a safety recall in accordance with federal regulation 573. However, it is deemed a safety improvement campaign by the agency. These vehicles were built with insufficient retention of the horn pad.

Defective left steering rack mounting supports were improperly heat treated resulting in the possible fracturing of the support.

Under certain conditions, the climate control blower does not operate as intended. The blower could (1) stick on "high;" (2) operate erratically with blower output varying between no blower and maximum blower; or (3) not operate at all due to malfunction of...

A static electric charge can build up on the ungrounded metal section of the fuel filler tube.