On certain trucks, an unprotected lead in the thermoswitch of the heater may make contact with another post possibly Creating a short circuit, which can result in continuous operation of the heating element.
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain trucks, an unprotected lead in the thermoswitch of the heater may make contact with another post possibly creating a short circuit, which can result in continuous operation of the heating element.
Certain sport utility vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 208, "Occupant crash protection." In these vehicles, the right front passenger seat is built with a passenger sensing system. When tested with a...
On certain motor homes built with cummins isl cm850 diesel engines, the connecting rod contains a machining defect in the wrist pin bushing of the rod that could cause a seizure of the piston pin.
Certain travel trailers fail to comply with the requirements of federal motor vehicle safety standard no. 110, "Tire selection and rims for motor vehicles." The tire inflation pressure label on the roadside front of the vehicle has incorrect air pressure...
Certain blue bird my 2008 all american and vision school buses manufactured between june 6 and july 27, 2007. A fuel pump failure will dilute the engine oil with fuel and cause loss of throttle control and excessive smoke.
On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.
On certain trucks, a manufacturing error in the fuel-water separator preheater thermoswitch may prevent the fuel preheater from turning off if the ignition is left on. If the ignition switch is left on when fuel is added to the fuel- water separator at the...
On certain passenger and sport utility vehicles, the automatic rear lid includes an electric motor and clutch that work in conjunction with two gas struts to open and close the rear lid, including a manual close function. If one of the struts has a total...
On certain trucks built with axilok rear wheel spindle nuts, the nuts may have been improperly installed, with one or both locking clip tabs not properly engaged or damaged.
On certain travel trailers equipped with suburban three burner match light gas ranges, the oven thermostat control valve can allow gas flow to the oven burner when the oven control knob is pushed in and not fully in the correct position to light the pilot.
On certain transit buses built with cummins isl engines, the exhaust elbow was incorrectly assembled and welded during production. The upper flange has a butt type weld instead of a fillet type weld.
On certain trucks, the screw bolts of the fuel tank fastening straps may not have been tightened correctly. After normal production process, the vehicles are disassembed for shipment to the us and the bolts may not have been correctly tightened when...
On certain pickup trucks equipped with four wheel drive, a section of the rear propeller shaft may have been improperly cast.
Certain airtex fuel pump module assemblies, p/n e7081h, sold for use as replacement equipment for the vehicles listed above. The wall of the flared fitting of the fuel pump is not thick enough to prevent the mating threaded fittings from bottoming out before...
Certain maxzone headlight assemblies, depo brand, p/nos. 315-1145L-as and 315-1145r-as, sold for use as aftermarket equipment for the above listed passenger vehicles. During production the lamp reflector shape deformed changing the shape of the optic...
On certain trucks, the nut used to retain the steering shaft may or may not be a lock nut that has the locking feature. A lock nut is required to provide additional resistance to ensure that the nut does not come loose.
On certain trucks, the nut used to retain the steering shaft may or may not be a lock nut that has the locking feature. A lock nut is required to provide additional resistance to ensure that the nut does not come loose.
On certain trucks equipped with tuftrac rear suspensions, the center casting brackets may be out of specification. An out of square casting may have unacceptable stress in the bracket when it is installed and may cause it to crack in service.
On certain passenger vehicles, the front seat belt tongue will not latch into the buckle and, in rare cases, even the locked tongue will pop out by low stretching force. If the buckle does not latch completely, the buckle could release without pressing the...